Solodigitalis Community Support

I have a DNP DS-RX1 using the WPS, is there any way to print a single 2x6 strip?? I think it would be a good way to save money on media.
Thanks

I'm not sure what you mean. You can print a 4x6 that is cut into 2, which is 2x2x6 in DNP parlance. That uses all the paper available.
If you select 3 photos, Wifibooth will mirror them so the two strips are the same.
If you select 6 photos, you'll get two different strips. Perhaps this is what you want?

I understand it prints a 4x6, cuts it in two. Can you have a different set of images on each strip??

Yes: if you select 6 photos, you'll get two different strips.

ok, so now what if the first group of people take their 3 poses. Then the next set takes their 3 poses. Will that print two separate strips for the two groups??

By default nothing prints and the user has to select what to print -- you've tried this right?
Or have you turned on autopilot?

using autopilot, it looks like that was the only way to automatically print images.

OK. Well you could either keep autopilot on and take 6 photos instead of 3, or, you could turn off autopilot