Page 1 of 1

Cut and Bleed on 2x6 Prints

Posted: Fri Sep 17, 2021 4:42 pm
by sustainednote
I have a DSP RX1-HS Printer and I'm using WifiBooth. I am printing mostly 2x6 strips by selecting the 2 strips portrait and having the DSP cut them for me. I haven't been able to find a setting in the "Layouts & Collages" that result in a clean cut without a white border around some unfortunate edge of each of the strips. The closest I got was no border, but then the logo at the bottom is cut off...

As seen in this photo: https://photos.app.goo.gl/QLuKFRUCUecAGgEi6

I'm currently set at

1% collage borders
1% inner border
Outer Borders ON
1% Outer border
0% Photo Border

I honestly don't really understand which each of these settings is referring to. Is there a diagram that can show me which elements of the photo these setting refer to?

Is this border clipping issue something I really must configure on my DSP printer? For such an expensive printer, it's quite daunting to try and configure.

Thanks!

Re: Cut and Bleed on 2x6 Prints

Posted: Fri Sep 17, 2021 4:58 pm
by tim
You’re very close!
What you are looking for is called print insets (bleed) and is shown in the print popover once a printer is connected.
You can try adjusting these values and you’ll be able to tweak it for your printer

Re: Cut and Bleed on 2x6 Prints

Posted: Fri Sep 17, 2021 7:32 pm
by sustainednote
Thanks Tim. I didn't realize there are settings there. I'll try it!