Cut and Bleed on 2x6 Prints
Posted: Fri Sep 17, 2021 4:42 pm
I have a DSP RX1-HS Printer and I'm using WifiBooth. I am printing mostly 2x6 strips by selecting the 2 strips portrait and having the DSP cut them for me. I haven't been able to find a setting in the "Layouts & Collages" that result in a clean cut without a white border around some unfortunate edge of each of the strips. The closest I got was no border, but then the logo at the bottom is cut off...
As seen in this photo: https://photos.app.goo.gl/QLuKFRUCUecAGgEi6
I'm currently set at
1% collage borders
1% inner border
Outer Borders ON
1% Outer border
0% Photo Border
I honestly don't really understand which each of these settings is referring to. Is there a diagram that can show me which elements of the photo these setting refer to?
Is this border clipping issue something I really must configure on my DSP printer? For such an expensive printer, it's quite daunting to try and configure.
Thanks!
As seen in this photo: https://photos.app.goo.gl/QLuKFRUCUecAGgEi6
I'm currently set at
1% collage borders
1% inner border
Outer Borders ON
1% Outer border
0% Photo Border
I honestly don't really understand which each of these settings is referring to. Is there a diagram that can show me which elements of the photo these setting refer to?
Is this border clipping issue something I really must configure on my DSP printer? For such an expensive printer, it's quite daunting to try and configure.
Thanks!