Solodigitalis Community Support

Hello,
Can I set this program, if I would like print one photo with logo, and after print same logo without logo. I make a guest book and I want the guest get gift photo with logo, and they get same phot without logo for the guest book! Can I set this in the event or I have to switch always! Thanks

Hmm, that is a tough one. There is one thing I can think of at the moment, but it is kind of a hack: if you have a printer that does strips/cut, and you're talking about printing out the photos for that guest book, then:
1. set layout / paper to portrait (_not_ 2-strips)
2. set number of photos taken to 5
3. set the logo to be "in collage" (whatever position you like, i'd guess position 3 at bottom of first strip is best?)
4. turn autopilot on to at least Collages
5. set your printer to cut (2x2x6)

Result: left strip of the cut has 2 photos plus the logo (in position 3), right strip of the cut has 3 photos (no logo).
I realize that's a bit odd, but it is an odd request