Selphy CP1200 - Event Tonight - Fit single photo with no white edges
Posted: Sat Nov 10, 2018 3:37 pm
Of course I have an event tonight and am trying to figure out how to print a single photo and have it fill the paper. I am currently getting stripes of white on either side of the photo - the photo is not reaching the perforated edges. The top and bottom of the photo are to the edge of the paper. So I'm assuming the camera is taking a photo that it not the same ratio as the paper and so it shrinks the photo to make it fit on the paper. Is there a way to fix this?
I am running Wifibooth on a 2nd Gen iPad Pro 12.9. I am using a remote camera, an iPhone 8. I am using the Selphy CP1200 printer. They are all connected on a DLink router which is dedicated to the devices used by the photo booth.
I selected 3.9x5.8 as the size.
I am not cropping - if I turn this on it will fill the printer paper poperly, but it crops far too much of the photo.
Inner borders is set to 0%.
Outer borders are turned off
Collage borders is set to 0%
Photo borders is set to 0%
Photos start zoomed-in is off.
I have already looked at this viewtopic.php?f=4&t=133, but it didn't make much sense to me.
I am running Wifibooth on a 2nd Gen iPad Pro 12.9. I am using a remote camera, an iPhone 8. I am using the Selphy CP1200 printer. They are all connected on a DLink router which is dedicated to the devices used by the photo booth.
I selected 3.9x5.8 as the size.
I am not cropping - if I turn this on it will fill the printer paper poperly, but it crops far too much of the photo.
Inner borders is set to 0%.
Outer borders are turned off
Collage borders is set to 0%
Photo borders is set to 0%
Photos start zoomed-in is off.
I have already looked at this viewtopic.php?f=4&t=133, but it didn't make much sense to me.